MAKERGEAR M3-SE, Руководство пользователя

Страница: 16 / 20

Shutdown & Reset Procedures
Do not switch off the power supply to turn off the MakerGear M3-SE.
There are two ways to properly shut it down:
1. Navigate to the printer’s OctoPrint interface and click the power
button icon. Next, click “Shutdown system,” then, “Proceed.”
2. To manually shut down the M3-SE, hold down the reset button for 10
seconds and release the button.
After performing either of these methods, you will hear a series
of tones indicating that the printer has a) started the shutdown
procedure and b) finished the shutdown procedure, and the green
light to the left of the red light on the raspberry pi will flash and then
shut off. Once the green light has turned off, it is safe to switch off the
1. Disconnects the printer from its current network and returns it to
Access Point mode (AP mode).
2. Resets the access point network name/password to its original fac-
tory state.
3. Resets the OctoPrint username/password to its original factory
state.
M3-SE Shutdown Procedures
The manual reset button, which is located on the front of the M3-SE,
resets the control electronics. The manual reset button should not be
used while the M3-SE is printing, unless you wish to stop the printer as
quickly as possible.
• Pushing and releasing the reset button will reset the control electron-
ics board.
• Holding down the reset button for more than 60 seconds before
releasing will begin the system restore process. This should only be
done in special circumstances, such as when passwords are lost. The
system restore performs the following operations:
M3-SE Reset and Restore Procedures
14