MAKERGEAR M3-SE, Руководство пользователя

Страница: 11 / 20

1. In OctoPrint, go to the “Temperature” tab to heat the extruder to
the appropriate temperature. In the “Control” tab, select the tool you
want to work with. If switching between filament materials (e.g., PLA
to ABS), heat the extruder to the hotter of the two materials’ printing
temperatures in order to purge the old material and properly extrude
2. In the “Control” tab, click “Retract” while pulling gently on the old fila-
ment until it is released from the filament drive.
3. Cut the end of the new material at an angle and feed it into the
filament drive. While applying gentle downward pressure, click
“Extrude” until you can see the filament extruding from the nozzle.
9
Changing Filament
You will not have to go through the setup process again unless you
change networks or factory restore the printer. After you’re connected
to the printer, proceed to OctoPrint’s Quick Check, which will help you
load the filament and ensure that the heated build platform of the
printer stayed level during shipping. Once you complete the Quick
Check, the printer will be ready to print.
Step 3: OctoPrint will inform you that you are not connected to the
internet. Click “ Wireless Configuration ,” then select your home network
and enter your home network’s password. Connecting may take a few
minutes. If OctoPrint continues to say you are not connected to the
internet, refresh the page.