MakerBot Replicator, Руководство по установке

Страница: 7 / 12

makerbot.com/docs/replicator 7
InItIal haRdwaRe setuP
STeP 5.
inSTall The caBle ReTaineR clip
With the build platform raised, you
have a clear view of the black cable
that leads from the electronics cavity
to the build platform. Attached to
the cable is a black cable retainer
clip. Now find the small round hole
slightly to the left of center at the
rear of the wooden plate below the
build platform. The clip should snap
easily into place.
STeP 6.
SecuRe The STepSTRudeR
®
Mk8 onTo The MounT
now we’re going to bolt the stepstruder mk8 into
place. Lower the build platform all the way by turning
the threaded screw behind the platform or by grasping
the black plastic arms at the sides of the platform and
pressing down with steady but gentle pressure. Retrieve
the feet and Bolts kit from the Accessory Box. Remove
the two black bolts from the box. next, locate your hex
wrench kit and find the hex wrench that fits the bolts.
Grasp your stepstruder mk8 by its sides and take it
out of its protective bag. Place it on the stepstruder
mk8 mount so the bolt holes line up and the fans face
forward. Secure it with the bolts and wrench.
Step 5. Snap the cable clips into place.
Step 6. Secure the Stepstruder MK8 with the
bolts from your Feet and Bolts kit.