Non-MakeID components are used.
8.
Malfunctions or damage due to force majeure such as man-made or natural disasters (e.g.
earthquake, fire, etc.)
9.
Other malfunctions or damage that is not caused by product quality issues.
This policy does not affect your legal rights as a consumer.
Under the environment with Electrostatic Discharge Test Results the
sample may be disconnected, but it can be resumed to normal operation by
user after test.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement.The
device can be used in portable exposure condition without restriction.
Warning:
Changes or modifications to this unit not expressly approved by
the
part responsible for compliance could void the user’s authority to operate
the equipment.