Make Noise Rene, Руководство пользователя

Страница: 29 / 33

The Select Bus
2 9
The Select Bus utilizes the often-inactive INT.CV Signal Bus Line in the Eurorack bus board system in order
to allow Select Bus communication for René, TEMPI and other modules designed to work with the Select
Bus standard. Up 20 Select-Bus enabled modules may be used on the same Bus Board. These modules
may be controlled simultaneously by Select Bus communications, simplifying the process of macro-
control over complex changes in a patch. The following Select Bus Communications are currently
implemented:
STATE Select: which STATE is currently active
STATE Default: sets currently Selected STATE to Defaults (these default settings will vary per module)
M-PASTE/ MESH Enable : sets a STATE to be Multi-Pasted or MESHed
M-PASTE/ MESH Disable: sets a STATE to NOT be Multi-Pasted or MESHed
M-PASTE: Initiates a Multi-Paste
STORE: writes all programmable parameters to non-volatile memory for storage and recall across power
cycles
Revert: restores the last STOREd version of memory
Before setting a module to LEAD or FOLLOW and attempting to utilize Select Bus communications, make
sure that your bus board has the INT.CV Signal Bus Line on it and that no modules are sending CV, Gate,
or any signals other than Select Bus communications.
To use the Select Bus, set one module to LEAD and one or more other module(s) to FOLLOW. See the
manuals for individual modules for a description of how to do this and to detail what Select Bus
communications the module will utilize. See the section in this manual on GBL.BUS for information on
how to set it with René specifically.
Modules currently known to communicate with René on the Select Bus
Make Noise TEMPI (René Leads)
Expert Sleepers Disting mk4 (René Leads)
Expert Sleepers General CV (René Leads)
Malekko Vari-Gate (René Leads)
WMD Sequential Switch Matrix (SSM) (René Leads)
Macro Machines Storage Strip (René Follows)