Make Noise PHONOGENE, Руководство пользователя

Страница: 15 / 15

15
Recycler: Record. Mult the Signal out, and patch to Signal IN MATHS Channel 1. Set
MATHS Channel 1 RISE and FALL so that the Activity LED is Flashing in time with the
transients of the recorded sound. This will usually put RISE at around 60% and FALL
at around 50%. Patch a dummy cable, or a manual gate, such as Pressure Points Gate
OUT, to Phonogene PLAY Pulse IN (14). Let Phonogene play to end of recording. Once
playback has reached end and stopped, patch the MATHS Channel 1 End Of Rise OUT
to Phonogene SPLICE Pulse IN (19). Now let Phonogene play through the recording
ONCE by either pressing manual Pulse once or removing the dummy cable and then
immediately re-inserting once playback has started. When Phonogene has played en-
tire recording once, and is stopped, remove MATHS EOR OUT from Phonogene SPLICE
Pulse IN. There should now be nothing patched to Phonogene SPLICE Pulse IN. Re-
move the dummy cable or manual Pulse from Phonogene PLAY Pulse IN. Using the
ORGANIZE Panel Control (13), audition the resulting Splices. If not acceptable, press
and hold SPLICE button (18) until the REC LED (17) starts flashing, re-install the ca-
bles to PLAY Pulse IN and then SPLICE Pulse IN, adjust the MATHS RISE and FALL
settings, and perform italicized steps again. Once you are satisfied with results, utilize
the ORGANIZE parameter to re-organize your loop. Try patching stepped/ clocked con-
trol sources to ORGANIZE, such as sequencers (René) and sample & hold (Wogglebug
Steeped OUT).
Sound Replacer: perform above Recycler patch. Once you have sounds isolated within
Splices, select the Splice containing sound to be replaced using ORGANIZE Panel Con-
trol (13). Patch new Sound to Signal IN (2). Set SOS (4) to Full Counter Clock-wise.
This next step is optional, patch EOS to trigger new Sound (perhaps use VCA and
Envelope to control new sound). When you are ready to record the replacement, mult
EOS OUT and patch to RECord Pulse IN. Once Sound is replaced, remove EOS from
RECord Pulse IN. When you are done replacing sounds, press and hold SPLICE button
(18) until the REC LED (17) starts flashing. Listen to the results.
More Patches to come, check back.