20
20304734
40ICFDV Gas Fireplace Insert
LOG PLACeMeNT
Before you begin
- This unit is supplied with nine (9)
ceramic fiber logs. Do not handle these logs with your bare
hands.
Always wear gloves to prevent skin irritation
from ceramic fibers.
After handling the logs, wash your
hands gently with soap and water to remove any traces
of fibers.
The positioning of the logs is critical to
the safe and clean operation of this heater.
Sooting and other problems may result if the
logs are not properly and firmly positioned
in the appliance. Never add additional logs
or embellishments such as pine cones or
vermiculite to the heater. Only use the logs
supplied with the unit.
Failure to position the parts in accordance
with diagrams below or to use only parts
specifically approved for this heater may re-
sult in property damage or personal injury.
INSTALL LOGS AND ROCK WOOL (eMBeR
MATeRIAL) IN FIReBOx
1. Break up rock wool (ember material) into small fluffy
pieces. Place evenly as shown.
Refer to Figure 22.
2. Apply a light layer of embers to the ports.
NOTe:
Excessive amount of embers will affect the flame and
the flame appearance.
NOTe:
Embers may be added
to entire burner area to hide burner and log support
brackets.
W
ARNING
Do not use the entire bag
of rock wool to cover
burner area.
W
ARNING
LG1141
40ICFDV embers
Ember Material
LG1141
LG1149
40ICFDV ember area
Ember Material Area
LG1149
Figure 22 -
Ember Material Area
Ember Material Area
