majacraft
8
8. Crank Assembly
7. Drive Bands
The black Bobbin Drive non-stretch band goes round the black groove
on the drive wheel, the small idler pulley on the tension adjust and then
over one of the black grooves on the bobbin drive whorl.
Required:
1 - Green Flyer Drive band
(in the hardware bag)
1 - Black Bobbin Drive band
(in the hardware bag)
The green drive band goes on the
lacquered grooves on the drive wheel
and then through one of the grooves on
the flyer whorl.
There are detailed instructions at the end
of this document for setting the bobbin
drive band tension.
The drive wheel has been
predrilled with the holes for
the aluminium crank assembly.
You will need a posi-drive
Align the holes on the drive
wheel with the holes in the crank
assembly and screw it into place
using the silver 32mm screws. It is
recommended that you insert the
centre screw first.
Required:
3 - Silver 32mm (1 1/4”) screws
(in the hardware bag)
Posidrive screwdriver
7a
7b
7c
7d
8a
8b
screwdriver and the three 32mm silver screws. Make sure the drive belts are on.
8c
