MP1800 Router Install Manual V1
.2
Install device on wall
Step 1: Use the impact drill to make the holes on the wall according to
the dimension shown in the above figure;
Step 2: Embed the plastic expansion screw into the wall and there should
be 3-4mm space between the screw end and the wall;
Step 3: Make the hang foot opening of MP1800 host aim at the expansion
screw, push MP1800 slowly, and fix the device on the wall.
Caution
The depth of the hole drilled on the wall should be larger than the depth of
the plastic expansion screw. The recommended external diameter of the
screw is 4mm.
Connect Host Cables
This section describes how to connect the control board cable of MP1800
to the network: connecting to console port of the router.
MP1800 provides one EIA/TIA-232 asyn serial console port. With the
interface, the user can adopt the character terminal with RS-232 serial
port (usually, it is one common PC) to configure the router.
For the details about the connection and configuration, refer to the later
chapters.
Maipu Confidential & Proprietary Information
Page
42
of
55
