INSTRUCTION MANUAL FOR DISHWASHERS
UK
Chap 6
SELF-DIAGNOSIS
The machine is equipped with a self-diagnosis system that can detect and signal a series of
malfunctions.
Anomaly
Description and possible remedies
E01
No rinse.
The warning comes on at the end of the cycle, if the water level in the tub is not
correctly restored. Check that the hydraulic connections are correct and that the water
tap is open. If the problem persists contact a technical assistance centre.
E02
Water drainage anomaly.
Water does not drain or drains abnormally. Check to see if the overflow has been
removed. Check the drain tube is not bent or crushed, and that none of the filters are
clogged. Run another drain cycle.
E03
Boiler temperature reset anomaly.
The boiler temperature reset has not occurred within the time limits set forth in the
wash cycle. Turn the machine off and then back on and run another cycle.
E04
Water filling anomaly.
Check whether the plumbing connections are correct, and that the water supply cock is
open. Check the presence of the overflow.
E05
Tub thermometer anomaly. (Probe open)
The machine does not measure the temperature in the tub. Turn the machine off and
then back on.
E06
Tub thermometer anomaly. (Probe shorted out)
Interrupt the programme in progress, and shut off the dishwasher. Turn it back on after
a few minutes and start the cycle again.
E07
Boiler thermometer anomaly. (Probe open)
The machine does not measure the temperature in the boiler. Turn the machine off and
then back on.
E08
Boiler thermometer anomaly. (Probe shorted out)
Interrupt the programme in progress, and shut off the dishwasher. Turn it back on and
start the programme again.
E09
Boiler loading time out
: boiler not filled. Impossible to carry out rinse cycle.
Check that the water tap is open.
Run a new complete cycle.
ESF
Electro-mechanical safety device:
the boiler or tub safety thermostats have cut in, or
the tub safety pressure switch has been triggered. Contact a technical assistance
centre.
ESL
Incorrect tub level
: the tub pressure switch has detected too much or too little water in
the tub. Contact a technical assistance centre.
E22
Tub heating time out:
washing water heating error, switch the dishwasher off and
then on again.
CAUTION! Turning the machine off and then back on resets the notification. If, after
following the instructions provided, the problem reoccurs, contact an authorized service
centre.
Page 11 of 14
