Mahr Millimar C 1200 M/T, Руководство по эксплуатации

Страница: 39 / 56

39
Mahr GmbH • Millimar C1200 M/T
Measurement Display Setup System
Customer calibration
Enable
Probe calibration
Factory standard calibration
Customer calibration Reset
Ó
ü
q p
ü
Ó
u q p
Calibration Min Nominal value Calibration Max
-1.000 -0 1.000
Measurement Display Setup System
Customer calibration
- 0 0 1 . 0 0 0
Measurement Display Setup System
Absolute mode
Customer calibration
Factory calibration
Factory settings
Keyboard-/ menu interlock
Info
Ó
ü
q p
ü
6.2.2 Executing a probe calibration
– Press the ON / OFF key
=> Standard menu appears
– Press
u
to select the System
menu
– Press
q
to select the Customer
calibration submenu
– Press
ü
to confirm
– Press
q
to select Probe
calibration
– Press
ü
to confirm or
Ó
to cancel
the selection
– Enter value for Calibration Min
(e.g. -1.000 mm). Press
u
to
select the required digit and press
q p
to enter the required value.
– Press
ü
to confirm or
Ó
to cancel
the selection
The device guarantees the highest accuracy after approx. 30 min operating
time. To conduct a reliable probe calibration, the calibration zero point that is
going to be used must first be positioned to the electrical zero point via the raw
value of the probe (see section 2.9, page 18). This is because the inductive
probe measures most accurately at the electrical zero point. A 1.000 mm gage
block would be the perfect electrical zero point for a probe calibration, like the
one in this example, where a 2.000 mm gage block is used for the MAX value,
the MIN value is obtained on a measuring plate.