Mahlkonig Pro M Espresso, Руководство по эксплуатации

Страница: 24 / 32

H O R E C A G R I N D E R
GB
24
ADJUSTING THE DOSAGE
The amount of ground coffee can be adjusted
via the control panes and the grinding time. The
touch sensors are the buttons and the slider.
The factory setting for dosing for espresso are:
Single shot: 5.0 s
Double shot: 8.0 s
Advise for grinding espresso: At these factory
settings at grind setting 2 the grinder will give
appr. 9g for a single shot and appr. 16g for a
double shot. (However this again may heavily
vary for different coffees.)
In order to change the dosing touch and hold
the respective touch button left or right of the
display until the time starts to blink red/white.
The time can now be adjusted be using the
touch slider below the display.
After the adjustment validate the new dosing
time by pressing the right touch button (green
mark)
START GRINDING
Condition:
The hopper is fi lled with whole coffee beans and
the grind time and fi neness are set.
1. Switch on the coffee grinder with the mains
switch (pos. 4) (rear side of the grinder).The
indicator lamp (pos. 7) lights up.
2. Place the port-a-fi lter of your espresso
machine in the port-a-fi lter holder. Grinding
starts automatically and stops after the
pre-set time.
BREAK-FUNCTION
With the break function you can interrupt the
grinding process (for instance to press down the
espresso powder partway through).
1. Remove the port-a-fi lter during grinding.
Grinding stops and the remaining time is
shown in the display.
2. To continue grinding push the port-a-fi lter
back into the port-a-fi lter holder.
If you do not wish to continue grinding after
break, tap quickly on the start/stop button (pos.
5) or push the respective touch button left or
right of the display.
BARISTA MODE
Push and hold both touch buttons next to the
display for one second to enter the Barista Mode.
The display shows a portafi lter. In this mode the
timer for dosing the espresso shots is switched
off.
3s