MAHLE ATX-2 PLUS BOOST, Руководство по эксплуатации, Страница: 12 / 19

Page 11
EMPTY USED
1. Connect red (positive) clamp on ATX Plus power cable to red (positive) terminal on vehicle battery.
Connect the black (negative) clamp to a ground on vehicle frame, vehicle engine is turned OFF. The ATX-
2 Plus
10 ft black and red hoses must be disconnected from the transmission .
READY light is off.
2. Place end of
8 ft black hose (left side of ATX-2 Plus)
in bulk used fluid container. Open ball valve on
the end of the hose.
3. Press the EMPTY USED button on the keypad.
4. Buzzer will sound and used transmission fluid will empty from the used tank inside the ATX-2 Plus to the
bulk container. Level can be viewed through the Level Indicator on the left side of the ATX-2 Plus.
5. Procedure will run until used tank is completely emptied or the STOP button is pressed. If process is
allowed to run until completion (30 seconds after used fluid tank is empty), the buzzer will sound
continuously and the PROCESS COMPLETE light will stay illuminated until the STOP button is pressed.
6.
Close ball valve
on the black hose and remove it from the bulk used fluid container.
EMPTY NEW
When switching between two different ATF fluids, cross contamination will be minimized by performing the
following
NEW
fluid draining process.
IMPORTANT: This process must be followed, to remove as much of the previous fluid from the
machine as possible. By following this process, cross contamination between different types of fluids
will be minimized.
1. Connect red (positive) clamp on ATX-2 Plus Boost power cable to red (positive) terminal on vehicle
battery. Connect the black (negative) clamp to a ground on vehicle frame. Vehicle engine is turned OFF.
The
10 ft black and red hoses must be disconnected from the transmission.
READY light is off.
IMPORTANT
:::: Empty USED
USED USED
USED Fluid tank prior to emptying the
NEW
fluid to minimize cross contamination.
Follow the EMPTY USED process to remove the used fluid from the used tank.
2. Couple any fitting adapter to the end of the
10 ft red hose (right side of ATX-2)
as shown below. Place
end of hose in bulk storage container for later use.
3. Press the
EMPTY NEW
button on the keypad.