MAHA DUO GN Series, Оригинальная инструкция по эксплуатации

Страница: 20 / 37

16 BA081101-en
3.3.6 Lowering
Closely watch the vehicle and the lift during raising and lowering cycles.
Do not allow anyone to stay in lift area.
 Press and hold LOWER button until lift has reached desired height.
Before starting the lowering cycle the lift will slightly raise to disengage the
locking latch.
Lift stops once button is released or downward travel stop is reached.
Make sure lift is
fully lowered
before removing the vehicle.
 Release parking brake, remove chocks.
 Drive vehicle off the lift.
If the lift is equipped with option "Set on Locks for Wheel Alignment", press and
hold the LOWER button until the green signal lamp SET ON LOCKS lights up.
This is to ensure troublefree operation of the automatic runway synchronization.
If equipped with option "Pinch Point Protection with Audible Warning Device“, the lift will pause
short of downward travel stop.
Release LOWER button and press again. A signal sounds until the lift is in bottom position.
If the lift is equipped with option "Floor Cover for Defined Axle Jack Position", the
lift can only be lowered to bottom position if the axle jack is in defined home
position.
Once the axle jack is in defined home position, the signal lamp AXLE JACK
POSITION goes out.