Español Italiano Nederlands Français
English
Deutsch
17
10.
Replace the cover with the membrane onto the reservoir. Oil will spill during
this procedure therefore do not forget to place a rag around the brake lever. Tighten the
cover screw until the cover is flush with the reservoir.
Use only the original Torx T7 bolt.
Any other screw will lead to leaks, damages and failure of the whole system!
Tightening torque 0,6 Nm/ 5 in.lbs
11.
Remove the syringe and screw in the 3mm allen bleeding screw.
Tightening torque: 2,5 Nm/ 22 in.lbs.
Re-position the brake calliper
(tightening
torque 6 Nm/ 51 in. lbs.).
Re-install the brake pads and the wheel.
Always pull the lever blade several times (pump) until the brake pads
touch the rotor.
Always check for correct installation by activating the lever blade and checking
for eventual leaks.
Never contaminate brake pads with oil or grease this causing permanent loss of
brake power! Contaminated pads are definitely dead and must be replaced! A conta-
minated rotor can be cleaned with MAGURA Disc cleaner, dishwater or alcohol.
10. The disc brake wheel
