MAGUIRE PRS-20, Установка, эксплуатация и обслуживание

Страница: 32 / 47

Maguire Products, Inc.
Edition: June 20, 2012 – PRS-20
32
Maguire Purging Recovery System
5.2 – Clearing a Material Jam due to Plastic Melt
When grinding some materials that have a low
melt index such as polystyrene, the material
can heat up to the point of melting and as a
result, can clog the shredder chamber. This
usually indicates that the Purging Recover
System is running too fast and should be
running a slower “Cut” speed.
In the event that material clog occurs, the Purge and Recovery System will
shutdown the Grinder, Shredder and Shuttle automatically. The blower will remain
on. If this type of a clog occurs, it will have to be cleared to continue.
The following instructions detail how to clear the clog.
SHARP EDGES: Wear gloves and use a block of wood to move
and "block" the rotor, or when attempting to remove partially
ground product or service the PRS-20 blades.
Knives Are Extremely Sharp!! Use extreme caution when placing
your fingers or hands near the rotor knives.
1. Turn off power to the Purge and Recovery System and follow
proper lockout / tagout procedures.
2. Open the front doors of the Purge and Recovery System and
locate the Transition Discharge (see picture to the right).
3. Remove the Transition Discharge.
Lift latch on right side of guides and swing 1/4" thick stop 90 degrees outward so discharge
can be removed While supporting the transition discharge, gently slide the chute outward
until it is removed from the machine.