MAGUIRE PRS-20, Установка, эксплуатация и обслуживание

Страница: 27 / 47

Maguire Products, Inc.
Edition: June 20, 2012 – PRS-20
27
Maguire Purging Recovery System
to insure all evacuation holes are clear)
12. Carefully Grasp The Rotor In The Center And Slowly Rotate
This is to assure that there are not any pieces of material preventing smooth operation
or that will prevent screen ring from being properly installed Carefully Align and reinsert
the Screen Ring utilizing the same reverse grip.
13. Reinstall the Transition Discharge
Slide the transition discharge in towards the back of the granulator cabinet until it stops.
Swing discharge arm stop against chute. Hold pressure against arm stop and press
latch downward to lock arm in place.
14. Release the 2 Discharge Chute latches on each side of chute & remove
15. Clean Out Chute area of all residual material.
16. Close & Secure the Front Access Door On The Sound Enclosure.
17. Fully Depress Reset Buttons for grinder & shredder thermal overload in control
box.
18. Restore the Electrical Power Source.
19. Plug in the Granulator.
20. Restart your Granulator. See Starting / Stopping the PRS-20 on page 19.
4.6 – Drain and purge Air Filter / Regulator
The purpose of the air filter is to remove moisture and
contaminants from the air supply and protect the air
components of the Granulator. The air filter must be
periodically purged of moisture.
Do not supply the Granulator with a lubricated air
supply. Damage may result. Use only a clean,
dry, oil-free air supply.
4.7 – Adjustments
Air Pressure
We recommend a pressure setting of 90 PSI while the Granulator is running .
The gauge should continue to read this setting even when the vacuum unit is on. If
it does not maintain pressure your supply line is not sized properly.
Do not supply the Granulator with a lubricated air supply.
Damage may result. Use only a clean, dry, oil-free air supply.