Maguire Products WEIGH SCALE BLENDER WSBMB Series, Установка, эксплуатация и обслуживание

Страница: 84 / 148

M A G U I R E P R O D U C T S , I N C .
84
W E I G H S C A L E B L E N D E R

However, we recommend that you specify materials this way:
REGRIND; all the materials that DO NOT require the addition of the ADDITIVES. Usually
this is your Regrind scrap.
NATURAL; all the materials that are the bulk of the mix. These will be RATIOED to each
other and will constitute the ENTIRE mix except for space needed for Regrind and Additives.
ADDITIVE; all the materials that are added to the NATURALS only; color, stabilizer, slip
agent, etc.
_CS
Set AUTOMATICALLY when you enter settings
_CS parameter stores the current setting that has been entered through the KEYPAD, "SET"
function, for this component. You could change it here, but the SET routine is the proper way
to alter this number.
This parameter can also be set to ASSIGN this component to one of the three
THUMBWHEEL switches. This also is normally done in the SET routine by using the SET
key followed by a letter key (A,B, or C).
When set to 10000, 20000, or 30000 the component will follow the TOP, MIDDLE, or
BOTTOM thumbwheel switches respectively. The SET routine is the proper way to assign
thumbwheels.
In the special case when there are four components, and two or more are naturals, then one
NATURAL can have its setting calculated automatically, based on the other natural settings,
so that all natural settings total 1000. This is done by setting the CS parameter to 40000.
This allows four components to be controlled by only three thumbwheel switches, three
assigned, and the forth calculated automatically by default.
If this is a four (or less) component system, then you are using this software because your
components are not NATURAL, REGRIND, COLOR and ADDITIVE. Our standard "FOUR"
software handles that combination in a simpler, more straightforward way. See KEYPAD,
STAR FUNCTIONS, *04 for a rapid way to set up your system for 4 or less components.
_AL
1AL
2AL
3AL
4AL
5AL
6AL
7AL
8AL
9AL
AAL
BAL
CAL
Sets alarm functions
_AL Alarm FLAGS. The underscore ( _ ) represents the component number, 1 through 9, or
“A” for component 10, “B” for component 11 and “C” for component 12. When material runs
out, or for some other reason material does not dispense fully, these flags will instruct the
controller what to do.
The last digit is number of retries before the action.
The next to last digit is the action:
00000 = NO ALARM, NO RETRIES
00001 to 09 = ALARM, Continue retries.
00011 to 19 = ALARM, Stop retries, Continue process.
00021 to 29 = ALARM, Stop retries, Stop process.
00031 to 39 = NO ALARM, Stop retries, Continue process.
00000 =
no alarm, no pause in process, no retries. This is sometimes useful for a Regrind
dispense.