Maguire Products MLS Clear Vu, Установка, эксплуатация и обслуживание

Страница: 23 / 38

Maguire Products, Inc.
23
MLS Clear Vu

Press and hold "SET LOAD TIME" button for 1 second.
All lights will flash and then go off.
Release button to resume normal operation.
ROUTINE 6. Enter a new delay time for starting to load.
When the sensor in a receiver becomes uncovered, the loader will usually begin
loading that station right away... zero delay. When station loading must be
synchronized with a blender dispense operation, as in the case of our CVB style
blenders with Synchronized loaders, then we must delay the start of loading for a
short time, usually about 10 seconds, to be sure the dispense is complete.
Loading with this style receiver interferes with dispensing, and dispensing also
interferes with loading. Loaders are normally shipped with zero delay. When
synchronized loading is required, change this delay to 10 seconds.
Here is the routine to change the address.
Turn POWER OFF.
Turn STATION 6 switch ON, all others OFF.
While pressing "SET LOAD TIME" button, turn POWER ON.
Hold for 3 seconds, while all lights blink rapidly.
Release when blinking stops.
For switch numbers: 1 2 3 4 5 6 7 8
We assign values of: 1 2 4 8 16 32 64 128
The lighted switches represent the current delay. Normally, no switches are lit.
To CHANGE this delay:
Turn ON the correct combination of switches for the new delay time in seconds.
Turn OFF all other switches.
For 10 seconds, turn on switch 2 and 4 (2+8=10)
Press and hold "SET LOAD TIME" button for 1 second.
All lights will flash and then go off.
Release button to resume normal operation.
ROUTINE 7. Set number of retries before alarm (When Routine 3 is enabled)
Turn POWER OFF
Turn STATION 7 switch on, all others off
While pressing the “SET LOAD TIME” button, turn POWER ON
HOLD button until all lights stop blinking, then release.
Turn off switch 7.
Turn on one switch for amount of retries (1 to 8 retries), all others off.
Press and hold the “SET LOAD TIME” button for 1 second.
All lights will flash and then go off.
Release button to resume normal operation.