Magtrol 6400, Руководство пользователя, Страница: 23 / 56

14
Magtrol Model 6400 Torque Transducer Display Chapter 4 – Manually Controlled Operation
OPERA
TION
4.1.3 S
YSTEM
P
ARAMETER
S
ETUP
Includes torque transducer selection, max power setup, direction input setup, as well as encoder and
torque scale factor setup. The following steps will provide instructions for both a standard and
custom torque transducer setup.
4.1.3.1 Standard Torque Transducer Setup
The basic system parameter setup for a standard torque transducer consists of three procedures,
which must be performed in the following order:
1. Torque Transducer Selection
2. Max Power Setup
3. Direction Input Setup
Torque Transducer Selection
Selects the torque transducer model in use.
1. Press and release SHIFT.
2. Press and release SETUP button. "MENU: SYSTEM" appears in the display.
3. Press and release SHIFT. The Torque Transducer Selection Menu appears in the display.
4. Use UP
S
and DOWN
T
buttons until the torque transducer model being used appears in
the display.
Max Power Setup
Sets the maximum power set point. Select from a range of 0.1 watts to 100,000 kilowatts.
1. Press and release SHIFT. The display appears as follows:
POWER/AUX TORQUE SPEED
Figure 4–3 Max Power Setup Display
2. Use UP
S
, DOWN
T
, LEFT
W
and RIGHT
X
buttons to select the maximum power set
point. The maximum power set point is used to indicate an overload condition. If the
power reading exceeds what was programmed, the following message appears in the display:
POWER/AUX TORQUE SPEED
Figure 4–4 Power Overload Display
To clear an overload display, reduce speed and/or torque, then press and hold SHIFT. The
unit will then return to the main menu.