3
Note:
The gas line will have to be located on the left front side of the unit so make sure that you run
the line around the bottom of the unit to the front left side with enough length to hook onto the gas
valve that will be located in the center front of the unit.
There are (3) 1" diameter holes that will have to be drilled. The hole on the far right of the unit also
has to be drilled all the way through the inner firebox and through the combustion air pan. This will
give you access to the bottom of the unit where the gas line and wiring will be routed. See Fig. 2.
Drill the right 1” dia. Hole 2” in from the right side
and back 3 ½” from the front door flange. The (2) 1”
holes for the air inlet are located 9” from each side
and 3 ½” back from the front door flange. Drill these
holes only through the inner firebox, not through the
combustion air pan.
Take the SP-40-ZC gas log kit out of the box and
check to make sure that all of the parts are enclosed.
The kit should include:
Main burner pan - (2) bags
of sand for natural gas or (2) bags of vermiculite for
LP gas - (1) bag of burning embers - logs - valve
assembly - spark igniter - hardware package ( includes valve assembly bracket, spark igniter
bracket, attaching screws )
NOTE:
Make sure that none of the parts are mixed up with the packaging and get thrown out. Sift
through the packaging carefully and then set the parts out of the way so that they do not get stepped on
and broken.
Assemble the valve to the valve assembly bracket using the (2) # 10-24 X 3/8" long screws provided
and the (2) # 10 washers. Place the washers over the screws and align the gas valve so that the gas
inlet is facing to the left. Tighten the screws securely.
Align the bracket on the combustion air pan located on the front center of the unit directly in from the
lower grill. Use the (2) #10 self drilling and tapping screws provided to attach the bracket. Fig. 4.
Valve Bracket
Spark
Valve Igniter
Bracket
Fig. 4
Next attach the spark igniter bracket using the
(2) #10 self drilling and tapping screws
provided. The bracket needs to be located to
the far right of the Combustion Air pan. See
fig. 4. When locating the bracket make sure
that it is not in the way of the gas lines or the electrical box located on the inside right side of the
cabinet.
Valve Assembly Bracket
Attaching holes (2)
pilot gas line
main gas line to
burner
Fig. 3
Gas
Inlet
Gas Valve
Valve Attaching
screws (2)
Inside of Firebox (3)
1” Dia. knockout
Combustion Air Pan
Gas Line access to burner
through bottom of pan.
Fig. 2
