Auto creaser
8
MC-35A
4 INSTALLATION
4.1 Uninstall the protection bar
Protection
bar
The first thing after unpacking and put
ting
machine on table is to uninstall
the protection bar.
4.2 Set the balance bracket
Balance bracket
Please be careful of the bracket from your hand when you are moving it to the
stand. Inset screw drive through the hole in red cycle, release the bracket to
fall, and then set them again.
4.3 Output tray, stops and guides
Unpack it , install the parts as per above illustration.
Note
: Set guide and stops according to the paper format.
The capacity of the tray should always less than 30mm(A3 ) to keep machine balance.
Side guide R/H Side guide L/H
Joint of tray
and machine
Output tray
Back stop
Extensio
n tray
