MM-R/MM-RC Remotes Instruction Sheet
4
© 2017 Sensata Technologies
Surface Mounting the MM-R and MM-RC Remotes
The remote control can be mounted on the surface of a wall by using the
supplied bezel. Refer to Figure 6 before you begin.
Info:
The bezel has tabs at the top & bottom that are made with
a thinner material. The tabs can be cut or broken out to allow the
communication cable to be routed up or down the wall.
•
Use bezel as a template to mark the four mounting screws.
•
Drill appropriately sized mounting holes (screws are not supplied).
•
Cut/break the appropriate tab on the bezel.
•
Pull the cable through the bezel and place the ring side with the removed
tab over the communication cable against the wall.
•
Position the bezel over the drilled holes and screw to the wall.
•
Connect the communications cable to the remote (see Figure 4).
•
Secure the remote display to the bezel with the 2 Phillips screws provided.
•
After ensuring the inverter is OFF, route the communications cable exiting
from the bezel to the Remote port (blue) on the inverter.
Screws x4
(not included)
Bezel Ring
Breakable tab
(allows cable
to be inserted)
Communication
cable (routed
down the wall)
BULK
ABSORB
FAULT
FLOAT
AC IN
INVERT
ON/OFF
Figure 6, Surface Mounting
Figure 5, Flush Mounting
Min. 1
½
"
Max. 1
⅝
"
Min. 2"
Max. 2
⅛
"
CUT THIS
AREA OUT
INVERT
AC IN
FAULT
ON/OFF
Communication cable
(routed in the wall)
