Magnum Energy Mini Magnum Panel, Руководство пользователя

Страница: 58 / 70

Page 49
©
2012 Magnum Energy, Inc.
Appendix A - Optional Equipment and Accessories
Refer to Figure A1-2 to locate the holes you will use to attach the charge controller to the bracket.
Before mounting the bracket, use the provided T20 Torx drive, thread forming screws to pre-thread
your selected mounting holes. It is easier to thread the holes now rather than doing it after the
bracket and controller have been installed.
After pre-threading your particular bracket hole(s), refer to Figure A1-3 to locate the enclosure
mounting holes you will use to attach the bracket to the enclosure. Before you mount the charge
controller to the attached bracket, remove the appropriate knockout from the side of the controller
and an adjacent knockout on the side of the enclosure. This allows you to use a one inch close
nipple with two locknuts to secure the charge controller to the enclosure (in addition to the bracket),
and provides a path to run the necessary wiring between the two units. Mount the controller to
the attached bracket using the supplied hardware. Insert the close nipple through the knockouts
and secure with the locknuts.
Info: It may take three locknuts on the close nipple to anchor the controller to the
enclosure. An additional locknut may be required between the enclosure and the
controller to act as a spacer. Also, a standard one inch plastic bushing should be used
on the nipple ends to protect the wire insulation as it enters/exits the nipple.
Figure A1-2, Charge Controller Bracket Mounting Holes
Bracket to enclosure
Torx screws
Controller Bracket
Mounting Holes
Enclosure
Charge Control Bracket
(left side)
Left Front View
Right Front View
Controller Bracket
Mounting Holes
Enclosure
Bracket to enclosure
Torx screws
Charge Control Bracket
(right side)
G
F
D
C
B
A
E
E
F
D
A
B
C
G