3.
Inspect the battery for cracked or broken case or
cover. If battery is damaged, do not use tester.
4.
If the battery is not sealed maintenance free, add
distilled water in each cell until battery acid
reaches level specified by the manufacturer. This
helps purge excessive gas from cells. Do not
overfill.
5.
If necessary to remove battery from vehicle to test,
always remove ground terminal from battery first.
Make sure all accessories in the vehicle are off to
ensure you do not cause any arcing.
OPERATION & USE:
1.
Remove the cover on the backslide bottom of the
battery tester.
2.
Insert the connectors which contain a black-yellow
pair and a yellow-red pair in one end of the lead
wire into the sockets which can be found when you
remove the cover as above. Be sure to make the
colors match between the connectors and sockets
as shown below:
INSERATION OF REPLACEMENT OF LEAD WIRE