TESTING
POINT TO BATTERY
PRESS ENTER
GOOD & PASS
XX.XXV XXXX SAE
GOOD & RECHARGE
XX.XXV XXXX SAE
5.
Press the
◄
►
key to confirm the location of the
battery if a surface charge is detected, follow the
tester ‘s introductions to remove the surface
charge.
6.
Testing battery.
7.
Aim
the
“Temperature
Measurement sensor” 2.5cm
(1 inch) from the top or sides
of the battery case and press
<<ENETR>>. Measured temperature may vary by
distance from the battery, under hood conditions,
and cabinet temperature.
8.
When the test is completed, the display shows the
results as follows. {Press the
◄
►
key to select:
Temperature, SOH (STATE OF HEALTH) , and SOC
(STATE OF CHARGE)}.
3
The battery is good and capable
of holding a charge.
The battery is good but needs
GOOD & PASS
GOOD & RECHARGE