7/12
LH70 initial Setup Manual
LH70-1, LH70-2
Diameter display
Display resolution
INPUT CHANGE
(display switching)
LABEL
(axis label switching)
Note
How to set up Detailed Settings (1/1)
(continued from Basic Settings)
Step 4
Make the detailed settings.
*If you have already completed the basic settings and want to reconfigure only
the advanced settings, you can do the same.
Basic Settings
Press the setup key
in the normal count display state.
D
e
ta
ile
d
S
et
tin
gs
Selection of each display axis and measurement unit input axis
Upper: input 1
Middle :input 2
Lower: input 3
Display example
LH70-3
Set by select axis key
・
Display resolution is set by pressing
key on each axis.
・
A value smaller than the input resolution cannot be selected.
・
Polarity changes with
key
・
To display the diameter (double display), turn on on the
display axis.
Angle display
Length display
Extended resolution
Press the edit key
No compensation
Error compensation off
Linear compensation
Linear Error
Error Setting
(compensation value)
Selection of error compensation function
default
～
Input a correction value of
±
0.600 mm for a distance of 1 m.
Input up to
±
1.000 mm when extended is selected.
～
Extended res.
Normal
Enter with the number keys
Liner Error
(Linear compensation)
default
Note 1
: Selection of a value smaller than the basic setting
length measurement unit resolution is not displayed.
Note 2:
The angle display can be selected when the angle
resolution is selected in the basic settings.
（
Note 1
）
（
Note 2
）
Note:
Can be used with LH70-1 and LH70-2.
The axis labels for the 1st and
2nd axes can be selected from
"X", "Y", and "Z".