MagneMotion MagneMover LITE, Руководство пользователя, Страница: 193 / 382

Installation
Transport System Installation
MagneMover LITE User Manual 7
Rockwell Automation Publication MMI-UM002E-EN-P - March 2016
Installation Overview – MMI Supplied Mounting
This provides an overview of the installation of the MagneMover LITE transport system using
the MM LITE transport system components, including stand, beam, and motor mounts.
1. Assemble a complete section of the system stand, including the stand and beam (refer
to
Assembling Beams on page 5-11 and Installing System Legs on page 5-12 ).
2. Adjust the feet on the stand section to ensure it is flat and level (refer to Leveling the
MagneMover LITE on page 5-15 ).
3. Secure the stand section to the floor or other equipment as required (refer to Securing
the Transport System on page 5-16 ).
4. Attach cable chase cover brackets to curve and switch motor mounts (refer to Install-
ing Cable Chase Cover Brackets on page 5-18 ).
5. Attach the motor mounts to all motors and switches (refer to Installing Motor Mounts
on Motors and Switches on page 5-19 ).
6. Install the motors and switches ensuring the guide rails are colinear to each other and
the tops of all motors are coplanar to each other and tighten the V-braces (refer to
Mounting Motors and Switches on page 5-20 , Align and Secure Motors and Switches
on page 5-23 , and Verify Motor and Switch Installation on page 5-26 ).
NOTE: If railless motors are being used, ensure the motor bodies are colinear to each
other.
If motors are installed in a CIP or wash-down environment it must not
exceed IP65.
7. Install the power supplies, Node Controllers, network switches, and cables (refer to
Installing Electronics on page 5-27 ).
8. Make all communications, network, and power connections (refer to Connecting
Motors and Electronics on page 5-32 and Network Connections on page 5-60 ).
9. Assemble the next section of the system following Step 1 through Step 8 and connect
it to the previously installed section ensuring both sections are in the same plane and
level to each other.
10. Continue assembling and installing sections until the system is complete.
11. Install the vehicles (pucks) on the system (refer to Installing Pucks/Magnet Arrays on
page 5-40 ).
NOTE: Vehicles (pucks) should be installed on closed loop systems before installing
the last motor to eliminate the need to remove a guide rail.
NOTICE
Ensure the stand system where the MagneMover LITE motors will be
mounted is properly grounded to safety ground (earth).