3
SAFETY PRECAUTIONS
Do not cover the intake or
exhaust openings with
cloths or towels.
A lack of air flow can lead
to overheating and fire.
Never insert your finger or
other foreign objects into grills
or openings. Take special care
to warn children of these
dangers.
Do not use in areas
where chemicals are
handled.
This will cause the unit
to deteriorate due to
chemicals and solvents
dissolved in the air.
Care should be taken when
using the unit in a room with
the following persons:
Infants, children, elderly people,
and people not senstive to
humidity.
You may be injured if you
fall or if the unit falls over.
Water may spill inside the
unit, causing insulation
failure and electrical
shock or fire.
!
!
It may cause failure of
appliance or accident.
There is danger of fire or
electric shock.
Do not place heavy object on the
power cord and take care so that
the cord is not compressed.
Operation without filters
may cause failure.
Always insert the filters
securely. Clean filter
once every two weeks.
CAUTION
Do not climb up on
or sit on the unit.
If water enters the unit, turn
the unit off and disconnect the
power , contact a qualified
service technician.
!
Do not place flower
vases or other water
container on top of
the unit.
The manufacturers’ nameplate is located on the rear panel of the unit and contains electrical and other
technical data specific to this unit.
Be sure the unit is properly grounded. To minimize shock or fire hazards, proper grounding is important.
The power cord is equipped with a three-prong grounding plug for protection against shock
hazards.
Your unit must be used in a properly grounded wall receptacle. If the wall receptacle you intend to use is
not adequately grounded or protected by a time delay fuse or circuit breaker, have a qualified electrician
install the proper receptacle.
Ensure the receptacle is accessible after unit installation.
Do not use extension cords or an adapter plugs with this unit.
However, if it is necessary to use an
extension cord, use an approved Dehumidifier extension cord only (available at most local hardware
stores).
To avoid the possibility of personal injury, always unplug the unit before installing and/or servicing.
Electrical Information
It may cause electric shock
or failure of appliance.
4
DEHUMIDIFIER CONTROL PANEL
Control panel
3
When you push the button to change
operation modes, the unit will make
a beep sound to indicate mode change.
NOTE:
The control panel of the unit you purchased may be slightly different
depending on the model.
Fig.1
Fan button
Control the fan speed. Press to select either High
or Normal fan speed. Set the fan control to High for
maximum moisture removal. When the humidity has
been reduced and quiet operation is preferred, set
the fan control to Normal.
2
Filter button
The check filter feature is a reminder to clean the
Air Filter for more efficient operation. The Filter
light(Clean filter l ight) will illuminate after 250 hours
of operation. To reset after cleaning the filter, press
the Filter pad and the light will go off.
5
Humidity Set buttons
7
: Down/Up Buttons
TIMER Set buttons
Use the Up/Down buttons to set the Auto start
and Auto stop time from 0.0 to 24.
The humidity level can be set within a range of
35%RH(Relative Humidity) to 85%RH(Relative
Humidity) in 5% increments.
For drier air, press the pad and set to a lower
percent value(%).
For damper air, press the pad and set a higher
pe
When adjusting humidity levels, the
CONTINUOUS OPERATION INDICATOR LIGHT
MUST BE OFF
rcent value(%).
6
Timer button
Press to initiate the Auto start and Auto stop feature,
in conjuction with the and key bottons.
3
Low fan
indicator light
Auto defrost operation on
indicator light
High fan
indicator light
Filter
Cont.
Fan
Timer
Filter
Full
Cont.
On Off
Turbo
Normal
Auto defrost
1
2
4
5
6
7
Clean filter
indicator light
Bucket full
indicator light
Continuous
operation on
indicator light
Timer on/off
indicator light
1
Continuous button
Press to activate the continuous dehumidifying
operation.
4
Power button
Press to turn the dehumidifier on and off.
*
