SPECIFICATIONS
Frequency response:
CD
5 Hz – 20 kHz (+/- 0.5 dB)
SACD
5 Hz – 40 kHz (+/- 0.5 dB)
Signal to noise ratio :
108 dB (20 Hz – 20 kHz, A-weighted)
Channel separation:
> 105 dB (1 kHz)
Output voltage:
1.9 V (10 kOhm)
Harmonic distortion:
< 0.0015%
Mains voltage:
230 VAC / 50 Hz
Electricity consumption:
Type
25 W
Standby 1.0
W
Fitted with:
2 x ECC 88
Playable formats:
CD-Audio, SACD, SACD-Hybrid, CD-R, CD-RW
Dimensions (wxhxd):
Main device:
430 x 90 x 330 mm
Main device incl. operational
elements/connecting terminals: 430 x 90 x 345 mm
Remote Control:
45 x 190 x 23 mm
Weight:
7.5 kg
Subject to technical change.
For further information please visit our website: http://www.magnat.de.
• Place the MCD 850 on an even surface. Observe the relevant clearance gaps as specified under
"Important safety instructions".
IMPORTANT
: Do not place any objects on top of the device (magazines, CD/record cases, etc.).
The ventilation slots located on top of the device must be unobstructed at all times!
• Connect an audio output (analogue or digital) to a suitable amplifier. Also refer to the operating
instructions for the device when doing this.
• Connect the supplied mains cable to the rear and then insert the other end into a 230V socket.
• Actuate the on/off switch on the rear side, the device is now in the standby mode.
• Switch on the MA 800 using the ON/STANDBY button on the front panel or the remote control.
• When the tubes have heated up the device is ready for use.
Note: With some SACDs a slight pause may occur between the titles.
The device has a high quality preamplifier stage which is equipped with two tubes. The tubes have a
very long service life when used under normal operating conditions (min. 20,000-50,000 hours).
If it is necessary to replace the tubes, please refer to a specialist dealer.
If you should encounter any technical problems, please contact your specialist dealer or
Magnat Audio-Produkte GmbH, Tel.: 02234807-0.
INITIAL OPERATION
SERVICE AND TECHNICAL PROBLEMS
TUBE REPLACEMENT
GB
10
