Magna BluePirat Mini 8 CAN, Руководство пользователя

Страница: 20 / 62

BLUEPIRAT MINI | USER MANUAL /
page 20 of 62

The logger is in an undefined state and will not record any data.
Only after rebooting the device behaves as expected.

The data on the SD card can then be unreadable when the SD card is removed during a
write operation.
If you turn off the BLUEPIRAT Mini with the
[ON / Trigger] button, you have 5 seconds to re-
move the disk before the logger can be reawakened.
7.7 ETH #3 and ETH #4
The network ports at the rear side, ETH #3 and ETH #4 , can be used for logging data.
Warning:
Don’t connect ETH #3 and ETH #4 directly to each other.
7.8 Multifunction connector 44-pol SUB-D HD
At BLUEPIRAT Mini 8 CAN / 4 CAN-FD / 8 LIN / 20 LIN / FlexRay this connector has these
functions, depending on the logger model:

Power supply KL 30 and KL 31

Clamp 15 KL 15

High Speed CAN HS-CAN

Low Speed CAN / Remote Control LS-CAN

CAN-FD CAN-FD

LIN LIN

FlexRay FR x Ch A / Ch B

Serial RS232

Analog-Digital IN ANA IN / ANA COM

Digital OUT DIG OUT

Broad-R-Reach
®
BRR
The pinning is described in chapter 15
Pin assignments and harnesses
Notice:
The logger is protected against reverse polarity of the power supply. But devices which
are connected to the logger can be damaged when the logger is connected in the wrong
way.
7.9 Multifunction connector 15-pol SUB-D
At BLUEPIRAT Mini MOST this connector has these functions:

Power supply KL 30 and KL 31

High Speed CAN HS-CAN

Low Speed CAN / Remote Control LS-CAN

Serial RS232

Analog-Digital IN ANA IN / ANA COM

Digital OUT DIG OUT
The pinning is described in chapter 15
Pin assignments and harnesses