FacilityPro POS 3000 manual, version MAN9 PS3000 UKED 4512.doc 14
1)
allow_refund
6
: default value 0
If the value is set to 1 the terminal can accept a negative amount from the POS
for a payment transaction. This amount will be added to the card balance and
will be distracted from the turnover counter.
2)
als_server_ip
7
: default value 0.0.0.0
IP address of the ALS or PIM server (please refer to the FacilityPro Manager user
manual)
3)
auto_token
8
: default value 0
There are two devaluation commands in the pos protocol, whereby in the one the
discount token is determined by the cash register (dispenser) and in the second
by the FacilityPro terminal. If the cash register employs the first command type
and yet you want the token to be determined by the FacilityPro terminal,
auto_token should be assigned the value 1. The FacilityPro terminal will then
always determine the token.
4)
display_balance: default value 0
value = 1: when card is inserted the balance is displayed;
value = 0: balance is only displayed when user presses ‘?’-button;
5)
idle_timeout: default value 5000
When the terminal is not active, two or three alternating screens will be shown
on the display of the terminal (see parameters Welcome text 1 and Welcome text
2 below). The parameter idle_timeout defines after how many ms the display
switches between the screens. If it has the value 0 the screen will not alternate,
only the first screen will be shown (default: WELCOME, YOUR CARD PLEASE). The
date and time will then not be shown.
6)
increase: default value 0
If the value is set to 1 the terminal can accept a negative amount from the POS
as a reload transaction. This amount will be added to the card balance and will
be NOT distracted from the turnover counter, but added to a separate counter for
the total revaluated to cards. This parameter does not yet function in the
present firmware version in which negative amounts sent from the POS are added
to the card balance and subtracted from the turnover counter. This parameter
will be incorporated in a future release of the firmware.
7)
no_pos_busy messages: default value 0
Due to protocol rules busy messages are sent to the cash register. Some older
cash registers do not like these, in which case this parameter can be set to 1.
This should be avoided with new cash registers.
8)
oc_dummy_cardnumber: default value 0
Only applicable to terminals that accept Chipknip (refer to footnote
Error!
Bookmark not defined.
). This parameter determines the card number that is
sent to the cash register to indicate that a Chipknip has been inserted, and that
is stored as the card number in the transaction record and will be shown in
reports. It is generally 0. Some cash registers cannot accept a card number 0 and
generally the value 2147483647 is then used (hexadecimal 7FFFFFFF).
6
For all Magnaboxes with firmware version lower than 3.42 the parameter allow_pos_refund
should be used and not allow_refund.
7
For all Magnaboxes with firmware version lower than 3.45 the parameter server_ip should be
used and not als_server_ip.
8
For all Magnaboxes with firmware version lower than 3.42 the parameter pos_auto_token
should be used and not auto_token.
