Magmaweld RS 200 M, Руководство пользователя

Страница: 17 / 144

17
www.magmaweld.com USER MANUAL | MANUEL D’UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
RS 200 M / RS 250 M / RS 300 M
EN
16-a
16-b
16-c
Be sure that the connections are fastened tightly. Loose or incorrect fastening may cause
overheating or gas leakage.
Figure 3 : Intermediate Pack and Grounding Pliers Connections
• Place the wire feeder on to the turn table on the machine.
• Connect the blue gas hose to gas outlet bush in front of the power source.
• Connect the control cable to the control socket in front of the power source.
• Connect the welding plug into the welding cable connection outlet in front of the power source.
2.4 Welding Connections
2.4.1 Connections of the Wire Feeder
2.4.2 Grounding Pliers Connections
2.3 Mains Plug Connection
For your safety, never use the mains cord of the machine without a plug.
• No plug has been connected to the mains cable since there may
different types of outlets available in plants, construction sites
and workshops. A suitable plug must be connected by
a qualified technican. Make sure that the grounding cable
marked with and a yellow / green color is present.
• After connecting the plug to the cable, do not attach it to the
outlet at this stage.
Figure 2 : Power Plug Connection
• Grounding cable sockets with different inductance values
allow welding with lower spatter in a wide current range.
Socket for low current and small wire diameters socket,
for high current and large wire diameters or
socket should be preferred.
• Connect the grounding pliers wire to one of the grounding wire
sockets on the machine and tighten by turning it to the right.
• To improve the welding quality, firmly connect the grounding
pliers to the workpiece as close as possible to the welding
area.
Installation