MONOTIG 220ip - MONOTIG 220ip AC/DC
EN
www.magmaweld.com
22
USER MANUAL | KULLANIM KILAVUZU
Pnt Mode
It is active when TIG welding modes are selected. By pressing the trigger once, ignition starts with the main current and
the welding continues during the set time and ends automatically at the end of this time.
• At the time the pnt mode is selected, most zones are bypassed in the TIG curve and only 3 options can be set. Final
gas time, main current and spot time.
• Spot time is the welding time in the pnt mode. Allows adjustment from 0.1 sec to 20 sec.
Example;
Let the set time be 2 seconds: When you press the trigger, welding starts and continues for two seconds and you can
finish welding automatically at the end of 2 seconds without releasing the trigger.
6- HF and VRD Mode Selection
7- AC Frequency and Balance Adjustment
5- Pulse Mode Selection
Provides switching to the Pulse function in TIG position. Pressing the button once will switch to active or off mode. The LED will
light when active. When the pulse mode is active, the other related functions (duty cycle, frequency amplitude, pulse frequency,
etc.) become selectable.
Pulse function reduces deformation by reducing heat input to the material.
High frequency
• Enables welding without touching the Tungsten electrode touching the material in TIG welding mode. By this means,
the tip of the tungsten electrode will not be deformed.
• Active in TIG mode.
• If you want to switch off the HF mode on the machine and weld with the lift TIG mode, press the HF key to switch off
the active HF.
Voltage Reduction
• It ensures that the idle voltage (voltage between the output terminals) is reduced below 12V when the machine is
running and no welding is performed.
• It may be required within the framework of occupational health and safety rules.
• Applies in electrode welding modes.
• Activate or deactivate by pressing the button. The LED will light when active.
Press the button once to switch to on or off position. The LED of the corresponding function will be active when lit.
Press the button once to switch between the parameters. These keys are available only on AC/DC models. Adjustment is
made with the adjustment knob.
AC Frequency
• Used to adjust the output frequency of the AC output poles when AC mode is active in TIG welding mode.
• Allows adjustment between 3-200 Hz.
• The factory default setting is 60 Hz.
• By this function, it is easier to break the oxide layer of the material.
AC Balance Adjustment
• AC determines how fast the pole change will occur.
• Allows amplitude adjustment when the AC mode is active in TIG welding.
• Has a setting range of 10-90%.
Usage Information
