EN
www.magmaweld.com
MONOTIG 220ip - MONOTIG 220ip AC/DC
15
USER MANUAL | KULLANIM KILAVUZU
• Secure the prepared torch by inserting it into the negative pole socket and turning it to the right.
• Screw the gas inlet of the torch to the gas outlet located on the front panel of the machine.
• Attach the connector pins, connect them to the trigger control connections.
• If a water cooling system is used, connect the hoses of the water-cooled torch to the water cooling unit.
• Secure the argon gas tube
(a)
with a chain.
• TIG Torch Connection; the trigger should be connected to the control socket with the terminals
1-2-3-4-5
as shown.
(1)
Soldering direction has been taken as the reference.
(2)
Soldering direction has been taken as the reference.
2.5.2 Gas Connections
Electrode
Diameter
(mm)
Nozzle
Diameter
(mm)
Welding
Current
(ADC)
Gas Flow
(lt/dak)
1.0
1.6
6.3
9.5
30-70
30-150
6-8
6-8
• Use safety regulators
(b)
and heaters according to the standards to work safely to achieve the best results.
• Keep the gas cylinder valve
(c)
open for a while, so that possible sediment and particles are discharged.
• Connect the gas regulator to the gas cylinder, making sure that the thread on the gas outlet of the gas cylinder and the regulator nut overlap.
• Connect one end of the cylinder hose
(d)
to the gas regulator and the other end to the gas inlet at the rear of the machine and turn on the gas
cylinder valve
(13)
.
• Adjust the flow rate with the flow regulating valve
(e)
.
• Make sure the connections are free of leakages.
2.5.3 Trigger and Pedal System Socket Connections
Installation Information
