Magmaweld Monomig 200ik, Руководство пользователя

Страница: 18 / 84

18 monoMIG 200ik
EN
www.magmaweld.com USER MANUAL | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
3.3 Connecting to Mains
Check the mains voltage before connecting the
machine to the mains.
When inserting the plug into the mains socket,
ensure that on/off switch is in the “O” position.
• Turn on the machine with the on/off switch.
• After hearing the fan sound and seeing that the mains lamp is on, turn off the machine by turning the on / off
switch to the “0” position.
3.4 Selection and Replacement of Wire Reels
• Open the cover of the wire feed section. The wire feeding system with 2 reels can be seen.
• Use wire feed reels suitable for the material and diameter of the welding wire to be used. Use wire feed rollers
with V groove for steel and stainless steel, serrated V groove for flux cored wire, and U groove for aluminum.
• When replacing the wire feed reels, pull the thrust bearing arm and lift the thrust bearings, then unscrew the
wire feed reels screws and remove the reels.
Figure 7 : Wire Feed System
1-
Motor
2-
Euro Connector
3-
Thrust Bearing Arm
4-
Thrust Bearings
5-
Wire Feed Reels
6-
T. F. Reels Screws
3
4
1
5 6
2
Both sides of the reels are marked according to the wire diameter.
Place the reels on the flange so that the side with wire diameter facing towards you.
0.8 mm
3.2 Menu Structure
Functions that are either on or off according to the modes are as shown in the table below.
Pre-Gas Duration
Parameter Value Range
Current Scale
Upper Current
Lower Current
Final Gas Duration
Burnback Duration
Spot Welding Active Duration
Spot Welding Passive Duration
0 - 10 sec.
30 - 200 A
200 A
30 A
0 - 10 sec.
0 - 100
0.2 - 20 sec.
0.2 - 20 sec.
1 sec.
30 - 200 A
200 A
30 A
1 sec.
0 - 1 sec.
1 sec.
1 sec.
Factory Setting Position 2 MIG Position 4 MIG Spot Welding MIG
Operation