Magmaweld ID 250E, Руководство пользователя

Страница: 15 / 76

15 ID 250E
EN
www.magmaweld.com USER MANUAL | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
2.3 Mains Plug Connection
For your safety, never use the mains cord of the machine without a plug.
• No plug has been connected to the mains cable since there may different types of outlets available in plants,
construction sites and workshops. A suitable plug must be connected by a qualified technican.
• After connecting the plug to the cable, do not attach it to the outlet at this stage.
2.5 Connections for MMA Welding
• According to the polarity of the electrode to be used, insert welding cables into the appropriate socket and
tighten them by turning clock-wise.
• Connect the earth clamp tightly to the workpiece as close as possible to the welding area.
The table below is a reference for the amperage setting of non-alloy
steels. Please follow the electrode manufacturer’s recommendations.
Figure 3 : MMA Welding Connections
Covered Electrode
Diameter (mm)
Recommended Welding Current
Rutile Basic
2.0
2.5
3.25
4.0
5.0
40-60 A
60-90 A
100-140 A
140-180 A
200-240 A
-
60-90 A
100-130 A
140-180 A
200-250 A
When plugging the power plug into the outlet, make sure that the power switch is set to “0”
2.4 Connection to Mains
• Check the 3-phase with a voltmeter before connecting the machine to the
mains. After detecting that each phase is 400V (± 40V), attach the plug into
the wall outlet.
• Start the machine with the on / off switch.
• Turn the machine off by turning the switch back to the “0” position after
hearing the fan sound and seeing the ammeter and voltmeter lights are on.
Figure 2 : Mains Connection
Installation