Magmaweld COMPACT Series, Руководство пользователя

Страница: 33 / 80

EN
33
www.magmaweld.com USER MANUAL | MANUEL D’UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
COMPACT SERIES / KOMPAKT SERİSİ
MAINTENANCE AND SERVICE
• Maintenance and repairs to the machine must be carried out by qualified persons. Magmaweld is not
responsible for accidents that may occur as a result of interventions by unauthorized persons.
• You can obtain the parts to be used in the repairs from our authorized services. The use of original spare parts
will extend the life of your machine and prevent performance losses.
• Always contact Magmaweld or an authorized service specified by Magmaweld.
• All warranty provisions will become void due to any interference not authorized by Magmaweld within the
warranty period.
• Make sure you comply with the applicable safety rules during maintenance and repair works.
• Disconnect the machine’s plugs from the mains before carrying out any repairs and wait for 10 seconds for
the capacitors to discharge.
4.1 Maintenance
Maintenance and Service
Daily Maintenance
• Wire Feeding Mechanism should be kept clean and roller surfaces should never
be oiled. Always clean the residues accumulated on the mechanism with the help
of dry air at each welding wire change.
• Consumables on the torch should be cleaned regularly. If necessary, it should be
replaced. Make sure that these materials are original products for long-term use.
Every 3 Months
• Do not remove the warning labels on the device. Replace worn/torn labels with
new ones. You can obtain the labels from the authorized service.
• Check your pliers and cables. Pay attention to the connections and strength of the
parts.
• Replace damaged / defective parts with new ones. Never add/repair cables.
• Make sure there is enough space for ventilation. Consumables on the optional TIG
torch should be cleaned regularly. If necessary, it should be replaced. Care should
be taken to ensure that these materials are original products for long-term use.
NOTE: The above mentioned periods are the maximum ones that should be applied if no problems are
encountered in your device. Depending on the work load and contamination of your work environment,
you can repeat the above processes more frequently.
Never operate the machine when covers are open.
Every 6 Months
• Clean and tighten the connecting parts such as bolts and nuts. Check the electrode
clamp and earth clamp cables. Open the side covers of the machine and clean it
with low pressure dry air. Do not apply compressed air from close distance to
electronic components.
• Periodically renew the water in the tank of the water cooling unit with clean,
non-hard water and protect it with antifreeze against freezing.
or