background image

• USE OUTDOORS ONLY.
• DO NOT USE THIS APPLIANCE INSIDE THE BOAT OR ANY ENCLOSED SPACE.
• GRILL RADIATES HEAT, CLEARANCE FROM CUMBUSTIBLES, 24” (61 cm) SIDE AND BACK, NEVER USE 

UNDER AWNINGS, PATIO COVERS, ETC

• CAUTION: ACCESSIBLE PARTS MAY BECOME VERY HOT. KEEP YOUNG CHILDREN AWAY FROM THE 

APPLIANCE.

• NEVER LEAVE HOT GRILL UNATTENDED.
• USE GLOVE OR HOT PAD WHEN HANDLING HOT GRILL.
• CHECK THAT VALVE SEALING WASHER (A) IS IN PLACE AND IN GOOD CONDITION  

BEFORE CONNECTING GAS CONTAINER.

• INSTALL CANISTERS IN WELL VENTILATED AREA AND AWAY FROMOPEN FLAME, HEAT SOURCE, OR 

OTHER PEOPLE OR FLAMMABLE MATERIALS.

• CAUTION: CHECK FOR GAS LEAKS EACH TIME CYLINDER IS CHANGED.
• DO ONT USE APPLIANCE IF IT HAS DAMAGED OR WORN SEALS; DO NOT USE AN APPLIANCE WHICH IS 

LEAKING, DAMAGED OR DOES NOT OPERATE PROPERLY.

• NEVER CHECK FOR GAS LEAKS WITH A FLAME!
• IF THERE IS A LEAK ON YOUR APPLIANCE (SMELL OF GAS), TAKE IT OUTSIDE IMMEDIATELY INTO A 

WELL VENTILATED, FLAME FREE, LOCATION WHERE THE LEAK MAY BE DETECTED AND STOPPED. 

IF YOU WISH TO CHECK FOR LEAKS ON YOUR APPLIANCE, DO IT OUTSIDE. DO NOT TRY TO DETECT 

LEAKS USING A FLAME, USE SOAPY WATER.

• ALWAYS LIGHT GRILL WITH LID OPEN.
• DO NOT OVER HEAT GRILL, SEE OPERATING INSTRUCTIONS.
• DO NOT BLOCK, RESTRICT, OR OTHERWISE OBSTRUCT COMBUSTION OR VENTILATION AIR OPENINGS.
• APPLIANCE MUST BE OPERATED IN THE HORIZONTAL POSITION ONLY.
• DO NOT MODIFY THIS APPLIANCE.
• CHECK THAT BURNERS ARE EXTINGUISHED BEFORE DISCONNECTING THE GAS CONTAINER.
• ALWAYS TURN GRILL OFF AFTER USE.
• CHECK THAT THE GAS CARTRIDGE IS EMPTY BEFORE CHANGING IT (SHAKE TO HEAR THE NOISE MADE 

BY THE LIQUID).

• NEVER LEAVE GAS CYLINDER (CONTAINER)  OR VALVE/REGULATOR CONNECTED WHEN STORED.
• STORE GAS CYLINDERS IN WELL VENTILATED AREA. 
• DO NOT STORE GAS CYLINDERS INDOORS, IN DIRECT SUNLIGHT, BELOW DECKS ON BOATS, OR IN 

LOCKERS NOT APPROVED FOR PROPANE OR BUTANE STORAGE.

• FOR MODELS A10-207-3 AND A10-217-3; USE PROPANE GAS ONLY IN DOT-39 NRC CYLINDERS. GAS 

CONSUMPTION ON THESE CYLINDERS IS 0.2 kg/h. FUEL STORAGE ON THESE CYLINDERS SHOULD 

BE IN COMPLIANCE WITH THE AMERICAN BOAT AND YACHT COUNCIL (ABYC) STANDARDS A-1 (9), 

MARINE LIQUIFIED PETROLEUM GAS )LPG) SYSTEMS.

• FOR MODELS A10-207-3-CE-2 AND A10-217-3-CE-2; USE PROPANE/BUTANE MIXED GAS (CAMPINGAZ)  

IN CYLINDERS CV-270, CV270 PLUS, CV-470 OR CV470 PLUS.  GAS CONSUMPTION ON THESE 

CYINDERS IS 0.2 kg/h. 

• IT MAY BE HAZARDOUS TO ATTEMPT TO FIT OTHER TYPES OF GAS CONTAINERS.

A10-207-3, A10-207-3-CE-2, A10-217-3, A10-217-3-CE-2

IMPORTANT SAFETY WARNINGS • 

READ ALL INSTRUCTIONS BEFORE OPERATING

2

A

Содержание MARINE KETTLE A10-207-3













Отзывы: