OPERATING PROCEDURES
USING GRILL WITH ON-BOARD LPG (PROPANE) SYSTEMS
WARNING: Do not overheat grill. Magma grills do not require pre-heating. Stainless Steel loses anti-
corrosive characteristics when subjected to extreme heat. Most grilling is done on low temperature with
the lid closed. If medium or high heat is required, grill with lid open.
LIGHTING INSTRUCTIONS
• Open lid during lighting. • Depress knob & rotate counter-clockwise to the “HIGH” flame position.
• Push Piezo Igniter. • Visually confirm ignition. • Turn knob to adjust flame.
• If grill does not light, insure that a burner electrode spark cap is directly above electrode.
• If the piezo ignition continues to fail to ignite the gas, see MATCH LIGHTING INSTRUCTIONS.
Propane (LPG)
Gas
Regulator
A10-225 LPG (Propane)
10' Gas Grill Conversion Kit
To other LPG
appliance
or use cap
Shut off
valve
Cylinder Valve
Gauge
Gas grill
Type 3
Valve
Solenoid
Typical Boat and R.V. Application
MATCH LIGHTING INSTRUCTIONS
(Back up system allows use of grill until piezo ignition system is repaired.)
• Open lid during lighting.
• Place flame up to burner through the match light hole.
• Depress valve and turn counter-clockwise to the “HIGH” flame position.
• Visually confirm ignition.
Gently insert valve stem into venturi tube upside down until fully inserted & rotate as shown.
• Magma On-Board LPG (Propane) Valves &
LPG (Propane) Low Pressure Gas Grill
Connection Kit allow Magma Grills to be
installed within a boats existing on-board, pre-
regulated low pressure LPG (Propane) system.
• Use only
Magma Type 3 Low Pressure
LPG (Propane) Valves.
See our
Valve
Application Guide
at
www.
MagmaProducts.com
for correct valve.
• In North America use
Magma A10-225 LPG
10' Gas Grill Connection Kit
in conjunction
with
Type 3 Valve.
Outside North America
check your local dealer for proper hose & fittings.
• A primary shutoff valve
(supplied with Gas
Grill Connection Kit)
must be used with this
control valve at point of connection into your
system. This allows shut off of gas supply to
hose leading to grill.
IMPORTANT!! • DO NOT CONNECT A HIGH-PRESSURE SUPPLY HOSE
FROM A NON-REGULATED TANK DIRECTLY TO GRILL.
Magma's grills are designed for use with small disposable propane canisters or with pre-regulated low-pressure
propane and optional low-pressure valves. Running high-pressure propane fuel supply lines on a boat is in violation
of American Boat & Yacht Council (ABYC) guidelines and is not considered a safe application. Additionally, impurities
found in larger refillable propane tanks may clog the small orifices in the high-pressure control valve/ regulator
causing it to lose performance capabilities and eventually fail. Regulating these tanks to 1/2 PSI and using this
pre-regulated propane with the correct low-pressure valve will insure safe, efficient performance of the grill.
5
Match Light Hole