Magliner Powered Stair Climber, Руководство по эксплуатации для пользователя

Страница: 24 / 50

24
Apply anti seize grease to bearing flange and locking bolt. Position as shown below for
reassembly. Place a quarter inch wide piece of masking tape on the bottom portion to hold
pins and springs in place while sliding bearing assembly over the small pins and small
springs. Be sure to remove tape before operating your Powered Stair Climber. Use snap
ring pliers to put snap ring back on.
Fig. 16c
Lock bearing housing in place by inserting a 2.5mm Allen wrench in the hole and rotate
until nestled against the lift arm. This will keep wheels from rotating while tightening. The
wheels should spin freely one way only. Reposition outer assembly over inner assembly
and tighten the screw with a 3mm Allen wrench.
Fig. 16d
17. Swing Arm Assembly
With the battery in place, position the swing arm out of way so the bolts are easily reached
(see Fig. 6a on page 10). Then, be sure to remove the battery from the Powered Stair
Climber so no power can get to the unit.
To replace the swing arm assembly (part number 005127), remove both wheels (see page
22). Remove safety flap (see page 19). Remove bolt on left side of swing arm where it
attaches to the bracket with a 5mm Allen wrench. Remove bolt on right side of swing arm
with a 6mm Allen wrench.
Apply
anti-seize
grease
here