Magliner Powered Stair Climber, Руководство по эксплуатации для пользователя

Страница: 19 / 50

19
Unhook the main wiring harness from the electronic card. In Fig. 11e, the main wiring
harness is the plug that has all the colored wires. The green plastic plug will unhook from
the white plastic terminal. Do not unplug by pulling on the wires as this will damage the
wires. If necessary, gently pry the green plug loose using a flat screwdriver.
Fig. 11d Fig. 11e
To begin reassembly of the main wiring harness, twist the orange and blue wires that run to
the round up switch together. Then, twist the remaining wires to the orange and blue wires
and pull the new wiring harness through the lower hole in the frame near the circuit board
with a 40 inch wire hook. Be careful to not strip the wire coating while pulling wires through.
Reconnect wires at all connections. Unhook the old wires and re-hook the new wires one at
a time into the connector according to the 1” guide that was kept earlier. Be sure the metal
clip hooks in properly. Reverse assembly.
Fig. 11f
Close up
of area
circled in
white
Metal clip at end
of wire should
hook into each
of these