Magliner CooLift CPA43, Руководство по обслуживанию

Страница: 7 / 64

1-800-MAGLINE (624-5463) Page 7 www.magliner.com
CooLift
®
REPLACING THROTTLE INTERLOCK BUTTON
TOOLS NEEDED:
#3 PHILLIPS SCREWDRIVER, FLAT HEAD SCREWDRIVER, 7/16” WRENCH,
NEEDLE NOSE PLIERS
Item Qty. Part No.
A Vertical handle assembly with throttle (includes
items below):
1 309667
B Handle 1 309627
C Mounting weldment for throttle 1 309765
D Pan head machine screw - 1/4”-20 x 1-3/4” long 1 80106
E Hex lock nut - 1/4”-20 1 80675
F Throttle interlock button 1 62042
G Cable for throttle interlock (in handle, not shown) 1 62057
H Throttle 1 309782
I Throttle cable (in handle, not shown) 1 62073
J Socket head cap screw - #10-24 x 1-1/2” long 2 80145
1) Place the CooLift on a level flooring surface with the holding brake engaged.
2) Turn off main power switch . Remove back panel. Disconnect the batteries.
3) Unplug throttle interlock button wiring harness from the main wiring harness that goes to the
controller (see below).
4) Carefully pull old interlock button out of the handle being careful not to damage the wiring. Use
the flat head screwdriver if necessary.
5) Remove wires from button.
6) Attach wires to the new button (quick connect tabs) by aligning the connector with tab and push
on. It does not matter which wire goes on which tab.
7) Carefully insert button into the hole in handle, and press in place.
8) Plug throttle interlock button wiring harness into the main wiring harness as shown below.
B
C
D
E
F H
J
Unplug throttle interlock
from main wiring harness
HERE.
This part of the main wiring
harness consists of two
RED wires.