Magio MG-332, Инструкция по эксплуатации

Страница: 17 / 20

15
Warning!
»
Do not turn on the device without water.
»
Before filling water, please pull out the plug first.
»
Use only distilled water for pour into the water tank.
»
Do not fill the water tank beyond the MAX indication.
»
Do not use hot water, the water temperature should not be higher than +50 °C.
»
Do not add perfume, vinegar, magnetically treated water, starch, descaling agents, ironing
aids, chemically descaled water or other chemicals as they may cause water spitting, brown
staining or damage to your appliance.
»
Do not use your bare hand as a supporting surface when you steam.
User manual
- The appliance can be used for creating a natural look and for quick touch-ups. For garments with
tough wrinkles and for a more formal look, it is recommended to use an iron instead.
- You can wrinkle garments more easily if you spread the laundry properly after you have washed
it. Hang the garments on hangers to dry them with fewer wrinkles.
- When you are steaming, press the steamer head against the garment, and pull the sides of the
garment with your other hand to stretch it.
- Keep the steamer head a slight distance away from dresses with frills, ruffles, ruching or sequins.
- For garments with buttons such as shirts, jackets and pants, close the first button to help
straighten the fabric. To steam sleeves, start from the shoulder area and move the steamer head
downwards. Steam while you pull the sleeve diagonally down with the other hand. For shirt pockets,
move the steamer head upwards while pressing against the fabric.
- During the steaming, small wet spots may appear on your clothes. Also because of the steaming,
the clothes may be a little wet. After steaming, leave the clothes to dry before fold in place or wear it.
- The brush attachment improves steam penetration to achieve faster and better steaming result
on thick and heavy garment such as coat and jacket. Brush is to be used together with steam by pressing
the steam trigger and slowly moving the bristles along the garments.
Operation
1. Remove the water tank by holding the side buttons on it and pulling it forward.
2. Pull up the cower of water tank and carefully fill the water tank with cold water.
3. Close the cower of water tank.
4. Install the water tank back correctly and monitor the water level to prevent water shortages
during use.
5. If it necessary, install the nozzle.
6. Unscrew the power cord for the entire length and insert the power cord plug into the wall
outlet.
7. The indicator light will start flashing. Wait until the light stops flashing. The device is warm and
ready for operation.
8. Press and hold the steam button supply. To supply steam continuously, lock the steam
supply button with the lock on it.
9. Launch the first portion of the steam before starting work, as it may contain droplets of water.
10. When finished, disconnect the appliance from the mains.
11. After about 30 minutes, when the device cools down, drain the water from the tank and
remove the device for storage.
2. Unreel the cord and plug into an outlet.
3. Before using the appliance for the first time, fill the tank with water as described in the
«Operation» section. And steam a piece of unnecessary fabric, this will remove any impurities
and odors that might have been left by the manufacturing process and to make sure the surface
is clean enough.
EN