Magigoo Coater, Руководство пользователя

Страница: 15 / 24

15
Instructions for Use
3.2.2
Coating
Magigoo Coater is designed and built for use in FDM/FFF 3D printing to cover the build plate
of a 3D print with a thin layer of Magigoo and Magigoo Pro bed adhesive to increase the
reliability of 3D print, reduce warping and provide easy release. Best results are achieved on
glass build plates.
Before coating with Magigoo Adhesives, read through the adhesive safety data sheet for
safe use. Before coating, check that the Coater valves and the thin film applicator are clean
and dry. If necessary, wipe the thin film applicator and valves with a damp cloth and/or wipe
dry. If the valves are clogged, clean the manifold first. See section 3.2.4 for Manifold cleaning
instructions.
How to apply:
1. Place the thin film applicator firmly
at the build surface at the far end
of the surface. Hold the system so
that the position of the valves are
perpendicular to the surface.
You should see 13 adhesive dots on the surface.
3. Press the thin film applicator firmly against the surface and slide across the bed,
spreading the Magigoo.
The thin film applicator is
static bar and does not roll.
Attempting to make the thin
film applicator bar roll may
cause irreversible damage.
2. Pump the coater once. If the new glue
bottle has been attached and not
primed, pump until the glue dots form
on the surface.
!