ReTransfer ID Card Printer – User Manual
37
did not match that of the printer. Therefore, the request was denied.
1056
Partner code programming dongle is corrupt
While processing a partner code dongle, the printer found that the
dongle's partner code was 0, which is not allowed. This may be because
the dongle is corrupt.
1057
File Read error
While preparing to print a demo card, the printer was unable to load
the image data from the selected card's PRN file on the SD card. This is
possibly because the SD card is either not programmed properly, or
faulty.
2048
Cleaning is overdue
During printer boot-up initialisation, while attempting to check whether
the printer needed to be cleaned, the printer determined that cleaning
was overdue. This error message is a prompt to the user to carry out
the cleaning routine.
2049
The printer has not been calibrated
During printer boot-up initialisation, while attempting to check whether
printer calibration was required, the printer determined that calibration
had not yet been performed. This error message is a prompt to the user
to carry out the automatic calibration and soak test.
2051
The printer is too hot to soak test
The printer was requested to carry out a printer soak test, but detected
that the heated roller was too hot (above 60 degrees Celsius). The
printer should be switched off and allowed to cool, and then switched
on without film fitted before retrying the soak test.
2052
No cleaning card
At the start of a roller cleaning routine, the printer was waiting for the
cleaning card to be inserted into the print engine. However, it took too
long for the cleaning card's leading edge to be detected at the print
position opto sensor. This is probably because the cleaning card was
not inserted, but if not then it could be that either the feed motor or
card drive motor was not functioning correctly, or the print position
opto sensor was faulty.
2053
Incorrect cleaning card type detected
At the start of a roller cleaning routine, and having already detected
what should have been a cleaning card being inserted, the printer
determined that the inserted card was shorter than expected and
therefore probably not actually a proper roller cleaning card. This is
probably because the wrong sort of card was inserted, or the card input
hopper was not removed before initiating the cleaning cycle.
2054
Cleaning card jam
At the start of a roller cleaning routine, and having already detected
that a cleaning card had been inserted, the printer was waiting for the
cleaning card's leading edge to reach the eject opto sensor. However, it
took too long for the eject sensor to become blocked. This is possibly
