ReTransfer ID Card Printer – User Manual
36
to be considered trustworthy. This could either be due to a faulty or
incorrectly fitted transfer index sensor or LED PCB. It could also be due
to something physically obscuring the transfer index sensor/LED during
calibration.
1045
Dye LED calibration failed
While attempting to calibrate the dye film LED, the printer found that
one of the required LED brightness settings was either too low or too
high to be considered trustworthy. This could either be due to a faulty
or incorrectly fitted dye sensor or LED PCB. It could also be due to
something physically obscuring the dye sensor/LED during calibration.
1046
Dye film not found
While validating the print options at the start of a print job, the printer
determined that film was required, yet no dye film was fitted. If dye
film is in fact fitted, it may be that the tag reader hardware is faulty, or
that the tag on the dye film is faulty.
1047
Transfer film not found
While validating the print options at the start of a print job, the printer
determined that film was required, yet no transfer film was fitted. If
transfer film is in fact fitted, it may be that the tag reader hardware is
faulty, or that the tags on the transfer film is faulty.
1048
Film is fitted. Please remove
The printer was requested to carry out a printer soak test, but detected
that film was fitted. All film should be removed before retrying the soak
test.
1049
No film is fitted
While initialising the print engine, the printer was unable to detect
either of the film RFID tags. This is possibly because neither roll of film
is fitted, or there is a problem with the RFID reader hardware.
1050
Printhead timeout
During a print job, while waiting for the Printhead to reach its target
temperature, it took too long to reach that target.
1051
Failed to read the SD card
While processing a newly-inserted soak test dongle, the printer failed to
open the dongle. This may be because the dongle was programmed
incorrectly, was the wrong dongle, was corrupted, or was faulty. It may
also be because the firmware needs to be updated to support the data
format.
1052
Failed to write to the SD card
While attempting to update the printer's partner code, the printer was
unable to save the updated identity information onto the SD card. This
is probably because the SD card is either not fitted correctly, not
programmed correctly, or faulty.
1053
Internal storage media absent
During boot-up initialisation, the printer's internal SD card failed the
authentication check. This may be because the SD card was not
programmed correctly, or was faulty.
1055
Partner code mismatch
While processing a request to reset the printer's partner code to 0 using
a partner code dongle, the printer found that the dongle's
partner code
