ReTransfer ID Card Printer – User Manual
35
1034
Transfer film panel timeout
During a print job, while printing onto the transfer film, the printer was
unable to detect the index mark on the transfer film. This may be
because the transfer film is beyond the end-of-film marker tape (i.e. has
run out), or the index sensor needs to be recalibrated, or the index
sensor is faulty, or the film cannot move due to an obstruction or motor
fault.
1035
Mag head home timeout
While attempting to return the mag head to the home position, the
printer first had to clear the head home opto sensor by moving the mag
head a short distance towards the front of the printer. However, the
head took too long to clear the head home opto sensor. This may be
because there was a physical obstruction preventing the head from
moving, or the head stepper motor is not working properly, or the head
opto sensor is faulty.
1036
Mag head move timeout
While attempting to encode a mag card in the forwards direction, the
printer had to wait for the mag head to unblock the head home opto
sensor. However, the head took too long to do so. This may be because
there was a physical obstruction preventing the head from moving, or
the head stepper motor is not working properly, or the head opto
sensor is faulty.
1037
Mag verify
The printer attempted to read data from a mag card in order to verify
an encode operation, but no data was found, not even leading zeroes.
This could mean that the card was loaded in the wrong orientation, the
wrong type of card was used, the mag PCB was faulty, the head stepper
motor was not functioning properly, or the head was physically
obstructed.
1038
Cover open
The printer was about to start a print job, and detected that the cover
was open. If the cover is not in fact open, it may be that the cover opto
sensor is faulty.
1041
Transfer film expired
At the start of a print job, the printer determined that the transfer film
currently fitted had run out of prints. A new roll of transfer film should
be fitted before retrying the print job.
1042
Dye film expired
At the start of a print job, the printer determined that the dye film
currently fitted had run out of prints. A new roll of dye film should be
fitted before retrying the print job.
1043
Both films expired
At the start of a print job, the printer determined that the dye film and
transfer film currently fitted had both run out of prints. New rolls of film
should be fitted before retrying the print job.
1044
Index LED calibration failed
While attempting to calibrate the transfer index LED, the printer found
that the required LED brightness setting was either too low
or too high
