Quick Start Guide
Ultra Electronics Card Systems
Page 18
MAGICARD Sicura Laminator
The Card Feed Hopper has been factory set for use with 30 thou cards. Should it
require adjustment, carry out the following procedure:
Adjusting the Hopper
J
Remove the hopper from the laminator,
remove the interface cable.
View the cards edge-on at the card exit
aperture and adjust the shutter screw
so that 1½ cards thicknesses are
exposed
.
Insert a stack of your normal cards to
be laminated. Cards should be flat for
correct feeding.
Re-fit the Card Feed Hopper and the
cable.
Check for correction operation.
