EN
Programming menu RESET
In case you wish to set all the function back to the pre-set, you can do so by the following
way. All the functions will be set to option 1.
Procedure:
1. Turn the ignition on and open the door.
2. For resetting the programming menu No.1, keep buttons
l
+
ll
pressed for 2 seconds.
For resetting the programming menu No.2, keep buttons
l
+
lV
pressed for 2
seconds.
3. Lights will flash and siren will beep once.
4. Within 2 sec. press the button
III
. Lights will flash and siren will beep once.
Press button
III
again. Lights will flash and siren will beep once.
Press button
III
again. Lights will flash and siren will beep once.
5. After few seconds siren will beep 3 times and the lights will flash 3 times to confirm
the reset of the programming menu.
VIII. CALIBRATION OF THE FUNCTION – HAZARD LIGHT MODE
In case
it is not possible to control hazard lights directly for the alarm needs, you can use
the hazard light button mode. In this case the alarm, using the lights output, replaces a
hazard light switch (Fig.1). In the programming menu 2-06 you can set the continuous
mode (Mode1) and the pulse mode (Mode 2).
Output - Lights
Lights - flashing
Lights Control
Unit
Relay contact bypassing
the hazard light switch
Light output (CN2-1 or 2)
Common input (CN1-6)
Hazard
Lights
Switch
Fig.1 Parking Lights output connected to the Hazard switch
Mode 2 – pulse
Mode 1 – continuous
Calibration
In case of using the mode 1 or 2 it is required to set the time of output closure.
In this case alarm will set exact durations, which are necessary for number of flashes used
when indicating the alarm status.
Before calibration the correct mode (1 or 2) in the Programming menu 2 must be set.
Procedure:
1. Switch the hazard light button on – car lights are flashing.
2. Open the door, turn ignition on and press the brake pedal.
3. Long press button
III
– siren beeps once.
4. Push the button on RPS sensor and hold it at duration of 10 lights flashes.
5. After loosing the button, siren will beep twice.
13
